March 28, 2011
by Richard James Winter
4,473 views
0 comments
I ordered a Cajon, but firstly I didn’t like the sound (it was from Schlagwerk and cost €155), and secondly the screws on the front were all chewed up, so I presume someone had already been using it and so … Continue reading
March 28, 2011
by Richard James Winter
1,739 views
0 comments
Here is a list of the tools and material I used for making my homemade Cajon. Continue reading
March 28, 2011
by Richard James Winter
1,224 views
0 comments
In the previous posts I listed the tools and materials you will need. Firstly, you need to make the sides. Take a look at your panels. Select the nicest ones, make sure the nice looking side is on the outside … Continue reading
March 28, 2011
by Richard James Winter
665 views
0 comments
The next step, after you are sure that everything is dry (this can take between 10 minutes and an hour for each brace – hence get lots of C-clamps), is to glue the sides onto the back. In the picture … Continue reading
March 28, 2011
by Richard James Winter
721 views
0 comments
The next step is to glue on the top and bottom. You do not need to saw them to size beforehand. Leave some overhang; you can cut if off afterwards with a sharp knife and then sand it down. IMPORTANT: … Continue reading
March 28, 2011
by Richard James Winter
870 views
0 comments
Now here we’ll screw on the front resonator panel. As I mentioned, you can also use a different kind of wood for this, such as beech, but plywood works fine too. It is screwed on so it can be removed … Continue reading
March 28, 2011
by Richard James Winter
689 views
0 comments
The last step is to make the feet. Cut off 4 pieces of wood from the 20mm x 20mm lengths, each 12cm long. After that, sand them down a bit, give them a rounded edge on the bottom and the … Continue reading